Indesit

Pmm indesit DFP 27B+96 Z washes but does not rinse dishes, the washing, drying and end indicators are on. The pause, salt, and rinse aid indicators are flashing. When you turn on the machine, the pump first turns on, then the main pump turns on, then the pump turns on again and water begins to flow and the washing cycle starts. After its completion, the machine drains the water and displays the...

Dishwasher Indesit DSCFE 1B10 S R
The tablet compartment is open at the end of the cycle, but uncollected salt hangs out of it.
The bottom shelf with dishes is still being washed somehow.
Top shelf - all dirty dishes remain.
I put a glass with vinegar and turned it on - it seemed like the water never reached it.
What could this be?

Absolutely new. Modes 5 and 6 work correctly. The remaining four, designed for more than two hours, work for about forty minutes, the END light is on. And that’s it... The dishes are, accordingly, damp and dirty. And that’s why I’m angry. How can I help such a problem? ?

INDESIT DSIC 3M19, control unit DEA 601, heating element burned out, replaced with a new heating element 220 volts. It worked for exactly 4 days and stopped heating again. The heating element is working, I checked it at direct 220 volts, it heats for a short time, everything is fine. But from the output of the block to the heating element, at the terminals there is not 220 but 119 volts. The...

Good day!
The pump model Askoll M311 RS074200 W11412000 Rew has failed. A 0.6A 60W Cl 180.
There are no such things on sale! What can replace it with (which model)? Thank you!
PMM Indesit DWL-DEA603-S

Good afternoon help in identifying CMD components on the PMM Indesit 0283.06 DEA 701 control board, thank you in advance.

Hi all. Problem with dishwasher indesit idl40. After washing, water remains in the machine. No indicators are blinking. The filter is clean. At the same time, in mode 4 - rinsing, the water is completely drained. Where to dig?

Help me figure out what the simultaneous blinking of the diodes means: wash - end of wash - start.

The Indesit DISR 16B dishwasher does not start washing, after a while a beep sounds and ALL (six) indicators start flashing.
Tell me who knows

Hi all. Help someone! The heating element is completely new, but any program is cold water. No matter what I did, I even acquired a brain, but it didn’t revive the heating element. Maybe there is a diagram? There, the zero immediately comes to the heating element through the temperature sensor, and the phase through the brain from the relay. I rang all the wiring (in case the lower harness...

Haven’t used it for two weeks. Indesit DSG 5737. Did not fill with water. Replaced the aquastop valve. The native was blown in both directions. With the new one it turned on, the water went to the transparent thing on the left side and turned off the valve. I disconnected the hose from the car, put the tube on the inlet, it does not blow through. Please advise where to dig.

Hello.
After several minutes, in any of the modes, the dishwasher beeps and the indicators begin to flash (on/off, first and third modes)

Good afternoon, please tell me. The machine stopped with a flashing error 1+2 (left) without draining the water. Repeated starts were not accompanied by the usual noise in the first seconds, and after 10 minutes there was a single beep and again flashing 1+2. After draining the water manually, everything began to blink almost immediately after start-up, but there was still no usual noise. I...

Good evening
question about the Indesit dishwasher
I finished washing, I don’t unplug the machine, I make a new bookmark and select the washing mode. I turn on the start and: the machine drains the water, then, without ceasing to drain, the water set is turned on and the machine draws and drains water at the same time, after some time (30-60 seconds) it stops, and after a few seconds the water...

Good evening everyone,

You need a diagram of the Indesit DIF 14 dishwasher control module. Understand which wires go into which cell in the 4-wire power supply module.

When installing the control board, I don’t know where to attach the sensor, which hangs on a wire soldered into the board. Stupid question, of course. Please tell me.

Good evening.

Dishwasher Indesit DFP 5847​

We have the following problem((

We bet on a certain mode, we start. The display shows a washing time of 2.25 hours. It washes for about five minutes, then the time suddenly drops by an hour, the water does not heat up. And as a result, the dishes are not washed properly ((Until today, they set it to the not full load mode, the main thing is on this...

Please help me understand the cause of the hum. pours water, drains it, warms it up, dismantled the heater and changed the bearings. The hum did not go away. The hum starts as soon as the water is heated. At times there is no hum. I just let the car rinse without heating, there is no hum. everything is working.

Hello. Please tell me what can happen with a dishwasher. She collects water and heats it. But he doesn’t wash the dishes.

Hi all. I came across a dishwasher in a rented apartment, Indesit D42, but it doesn’t seem to do what it should. I started the washing program, the dishwasher took in a little water and began to hum monotonously. No more signs for 20 minutes.
I decided that it was a breakdown, partially disassembled it, got to the ten, measured the ten for resistance - the multimeter shows different values...

Dishwasher Indesit 051 EU. A year of use - excellent. The dishes were shiny. Powder-salt-rinse aid. Sometimes I use tablets. I didn’t change the detergent. No, I did, but everything was fine. And now she’s started to cower. A white coating began to appear on the dishes. It is washed by hand. But who needs such work... There is this coating on glass, on pots everywhere. Even if it’s 70 grams,...

Good afternoon I encountered the following problem: PMM indesit dsg0517. She served faithfully for 5 years. But trouble happened. The machine stopped washing dishes.
Water is drawn up to the level of the door, then some sounds are heard, similar to a boiling kettle. That’s all. The sprinklers do not spin. After turning off the machine, the water drains normally. Knowledgeable people, tell me...

When the program starts, the machine drains the remaining water and fills with clean water. After 1.2 min. water intake, a short signal sounds, drain and error 5.
The whole joke is that if, when drawing water, you turn off the supply tap until the machine beeps, and open it again - no error occurs! It continues to work as expected, but until the next drain-fill cycle. During the next process of...

Hello forum members, when we moved and parked, we forgot to drain the water from the salt container, so in short we defrosted it. Please tell me if anyone has a used or new one or an analogue as spare parts. The indesit dishwasher model D3010WN, manufactured in the late 90s-2000s, worked like a clock all this time.

The machine works, but when you add water, a glass of water flows out somewhere on the side of the machine. When he washes nothing flows, he starts collecting a glass of water for rinsing again on the floor. I tried to remove the side cover and couldn’t, I’m afraid I’ll break the front strap that holds it in place. Where can I see how to do this? Help!

The Indesit D61 machine suddenly started overflowing water yesterday. :( :( :(
What could be the problem? Maybe the level sensor is covered? Where is it located? I machine I looked it up, but I can’t find it.

Good afternoon
On the Indesit dfg 26b1nx dishwasher, the Askoll m306 recirculation pump broke (its markings are shown in the photo)!
You can’t find just such a pump anywhere, there’s not even any information!
Externally similar to m233, but it is 45cm for a car, and this one is 60cm!
Please tell me where I can find it or what other one I can replace it with!?
Thank you so much for the quick...

Hello. The situation is as follows: the tray with detergent stopped opening during the washing process. They called a technician, and upon opening the front panel on which this tray is located, a wire from the terminal that connects to this tray was found to have fallen off. Well, naturally they returned it back and everything worked. The next day the same story - the tray does not open. So as...

I’m already desperate to look for an answer to my question on the Internet, maybe someone here can help.
I have an Indesit DSG 5737 dishwasher.
Suddenly it started screaming like a motorcycle at full speed. And water does not flow to the lower rocker.
I took off the cover and scratched my head - what and where and how?
In our village there is not a single service center, or even just a...

Dishwasher Indesit 5377, served for a full 3 years. Now the problem... With any program: drains the remaining water, puts new water into the pan, after which error 5 beeps and immediately drains. Such cases happened several times, isolated, a couple of times a month. I thought it was some kind of glitch. And now it’s a complete mess. What’s the catch, what should you prepare for?..

We have Model
Indesit ICD 661 S
After washing I find these marks. Where to go, what to do?
Photo link
http: //s49.radikal.ru/i125/1501/42/1cf8c4c87394.jpg

Kinder, Kirchen, Küchen - this phrase has become a household word as an example of the exploitation of women. Like, don’t stick your nose beyond the kids, the church, and the kitchen.
What now?
Kinder - either in kindergarten\school or with a nanny
Kirchen - don’t tell my slippers! The example of Pussy Riot is indicative, young mothers came there to make faces
Kyuchen - and there is a slow...

Good day! Indesit dishwasher, service life 1.5 years. After I washed the dishes with the filter not tightly screwed on (I accidentally forgot to screw it in after rinsing), the dishwasher stopped starting. I called the technician, he did it, washed the dishes 2 times, again the same problem. He recommended cleaning it with citric acid, and it worked again. It only starts every other time. When...

Actually, the question is in the title. My Indesit DSG 051 (electronics) is broken, now I’m thinking about where to attach it, because... bought a new one. :wink: