General questions about dishwashers

Hello everyone, I have an indesit DIF16T1A dishwasher
The following problem has arisen: after washing, the dishes are covered in drops and generally do not dry at all. Previously, you opened the door after washing and steam came out, but now the dishes are barely warm (but during washing the water heats up as before). One more thing, the rinse aid has stopped being used up. I removed the...

Hello everyone, tell me what could be the reason for the appearance of pinpoint rust stains in the dishwasher and how to deal with it, is there any point at all or is the machine scrapped? Salt I applied it once, after which I immediately started the wash; the stains appeared after two weeks of using the machine. Brand Tuvio, model DF63PT8XI1
P.S. In the photo there are white stains from soda, I...

Hello everyone, there is no power to the heating element of the dishwasher.

Hello everyone.
Almost a year ago, we installed the first PMM in our life, it was connected by repairmen who assembled the kitchen (built-in PMM).
Until recently, everything was fine, but now almost a day after using the PMM at the bottom We find cloudy water, there is no obvious sewer smell, but this is not clean tap water either.
IMG_20231120_194650.jpg

We start the PMM every day at 22-23...

Door won’t close dishwasher, the rinse aid indicator is constantly on, although rinse aid has been added. The door opens immediately and the dishwasher does not start

Help me find the 39-26 oil seal of the PMM DEXP engine.

What is this and what is it for?) IMG-20230915-WA0001.jpg

Good afternoon, can you tell me if there are dishwashers with a depth of 54 cm or 54.5? Or are they all 55cm? We bought an apartment with a suite, and literally one centimeter is missing to install a dishwasher(

I loaded the dishes, did not notice that the spatula was high and did not allow the upper rocker to rotate. I’m afraid it’s broken now, how can I check its condition? Are there any fuses that would save him?

Good afternoon A question. We bought a Lex dishwasher and had a kitchen assembler do the installation. I installed it with a plank on top, citing the fact that the height of the legs was not enough to install it correctly. The problem is that during the operation of the PMM, steam comes out and at first this plank swelled on one edge (it was replaced with a piece of the table top), now the façade...

Dear forum participants!
Unfortunately, our hosting provider had an accident, and the data was restored only as of July 16th.
We apologize for the loss of data over the last 6 days ((

Hello everyone) We bought our first dishwasher, at first it washed perfectly, but now we started to notice a little foam remaining at the bottom, the dishes are dry after washing, but if you pour water into a glass, the water in it is foamy. Even if you run it without a tablet, it’s also soapy dishes. The drain is clean, the impellers are also clean and spinning, I don’t know what to do anymore....

Hello everybody! The other day I purchased a dishwasher Bosch SMV25BX02R is a display sample, and it seemed strange to me that there is insulation on the top and right (sort of like green felt), but there is none on the left. As if he should be there. Please tell me if it should be there, and why is it even needed? What are the consequences if he is not there on the left? I called the store, they...

Good day!
Does anyone know what the voltage is on the Hotpoint Ariston 11677 engine?
I need to check (outside the dishwasher) whether the engine is working (I’m going to buy it).

Hello dear craftsmen, perhaps colleagues in related areas of repair. In general, I want to buy a full-size freestanding sink for my home. There’s just one thing, though, and that’s the quality of the PMM. Now all household appliances are made in such a way that they can fulfill their warranty period and die safely. And naturally, since I have no experience in repairing these wunderwaffles, I...

Dear friends, please help.

Tell me how to choose a dishwasher instead of the previous one. Do I understand correctly that the main thing in all this is whether it is full-sized or narrow, and all sizes are standard? I have a dishwasher ESL65070R
911435003/07, I want to change it to BOSCH SMV24AX00K. Will it fit in the old place?

Good afternoon. Help me find a temperature sensor for VESTEL VDWL 4513 CX.

Is it possible to connect a PMM without an aquastop with a simple hose and how?

Please tell me which of these dishwashers to buy. SPV4HMX2DR or Gorenje GV561D10

Hello! Maybe someone knows and can tell me which lock is suitable for the Ariston LSI48A dishwasher and where it can be ordered. And so, there is a lock on the door itself, but there is no response part...

Good day everyone!

I have a question: the sink is completely clogged and the dishwasher drain is connected to it. I poured Pink Mole (lye) into the sink, which naturally ended up in the dishwasher, since the sink was full of water and the dishwasher was constantly pumping the water back, which was poured into it from the sink through the drainage system.

After removing the blockage, everything...

In the CANDY cdcp 8 dishwasher, the leakage indicator went off, I took it apart and saw that the entire bottom of the salt tank had been torn by ice (this is at the dacha). I called all the services, they say there is temporarily no supply - sanctions. One service offered to make a fake . Somehow, let the water run directly past the tank, mess up something with the sensors... They ask for 10,000...

Is it possible to connect a PMM without an aquastop with a simple hose and how?

Hans dishwasher 416. I turn it on, drains, fills, thinks and drains. The dishwasher is not leaking, the water pressure switch is activated, the tube and chamber are not clogged. Help me to understand!

Hans dishwasher 416. I turn it on, drains, fills, thinks and drains. The dishwasher is not leaking, the water pressure switch is activated, the tube and chamber are not clogged. Help me figure it out!
Win! There were no clamps on the water relay hose and the silicone hose expanded when heated and released pressure. The breakdown was very clever, I had to break my head, and there were no clamps...

Please tell me what model of Gorenje dishwasher is this, black with one button and a thumbwheel?, the inscription has been erased, I can’t read it, and the instructions have long been lost.

Good evening! Please tell me, a tablet fell into the salt tray, what should I do? I couldn’t get it out; there was water and salt in there. Is it possible to run it like this?

All washing mode buttons stopped responding to pressing (when I press it lights up, when I release it goes out) except for on/off. Eco mode and time 3:15 automatically starts flashing and the process does not start. Tell me what the problem is. Thank you!

Good afternoon There is a Beko 6630S dishwasher with burnt out switching and control modules. I plan to make my own switching and control board. I don’t have a clue how the water filling system works.
Well, more precisely, I know that the valve opens, then the water flows through the pressure switch into the working chamber. When there is water, the pressure switch opens the reed switch, but how...

Hello everybody. Briefly, I used Somat powder and a white coating began to appear, so I switched to Mr. Dez. At first the car was shiny. Then the raid intensified. By eliminating the compartment: rinse aid, powder. The ion exchanger remains. He took it off, washed it, and put it in a bowl of water and salt. The valve rang, Working. Assembled and launched. There have been no flights for three...

The bearings worked for 20 years, there was a noise, the motor was on rivets, I drilled it out, installed the bolts, they are SKF, I will change it to Koyo.

The husband has his hands full. But he still can’t figure out what’s leaking. It’s leaking into the pan under the car itself. The only option is to remove the pan, put it on four stools and see what’s leaking. I checked all the connections, all the seals, covered everything with gasket sealant just in case case, even the float, hoses, chambers. Suspects that the engine seals may be leaking. Could...

Good afternoon!
Today the light on the lack of salt came on, I went to add it and discovered that the hole for salt was not closed!!! Apparently I forgot to close it after adding salt last time. And the lid still lay on the bottom. And after all, I washed the dishes like that for quite a long time. Moreover, this did not affect the quality of the wash in any way.
I started pouring salt into the...

Yesterday the dishwasher gave error E8, there are only 5 errors in the manual. The wash cycle is running, but the water is cold and the dishes are not dry. Has anyone encountered this?

Good afternoon!
Recently a problem arose with the dishwasher: a chemical smell appeared after washing, this has never happened before, it stinks very strongly, you can even taste the chemical when you eat from a plate or drink water.. I don’t understand, the tablets were not changed. ..

PPM Bosch SGU56A05, old (about 15 years old). It works faithfully, but six months ago the AquaStop system sensor began to constantly trigger when filling with water. An autopsy showed that the overflow valve (Aquastop system valve) and adjacent pipes are clogged with mucus and some kind of organic deposits, as a result, water does not flow into the PPM chamber at the required speed and overflows...

Good afternoon. Please tell me which built-in dishwasher to buy with the following criteria:
Beam on the floor with a timer,
Full protection against leaks,
The third full tray for cutlery.
Removable shelves (so that you can fit plates and a baking tray),
To dry well (and wash of course),
With a program for washing glass.
Ideally with a quick half-hour program.
Quiet enough and generally of...

Tell me, is it possible to connect a Hansa dishwasher to the station without an adjusting valve?

There is a need for hygiene functions. Please tell me which dishwasher has the maximum temperature setting. Judging by Bosch it is only 70°, Kandy is already 75°. Maybe there are higher models and it would be nice without an inverter. Budget up to 30 thousand.

Comrades! Please give me advice on what to do in this situation. I was putting dirty dishes in the dishwasher and a knife slipped out of my hands and stuck straight with its tip into the metal panel inside the dishwasher, I was glad there was a hole of 1-1.5 mm.
I’m thinking of sealing it with cold welding for steel. Tell me, please, will it be possible to pull this off, will it hold up? Is it...

8xw3SRPS22U

Hello, tell me how to find out the hardness of water (Chelyabinsk)

Machine beko dsfs 6830x, width 45 cm.
The lower basket has completely fallen into disrepair - almost all the plate holders have broken due to rust. It is necessary to change the basket, but a new one costs from 4500 rubles, or even 6000 rubles, which is comparable to the cost of the same assembled used machine on Avito in working condition (I found several pieces for 5000 rubles).
Basket article...

Our Ariston dishwasher is 20 years old, we are not going to change it, because they don’t do that anymore, it washes better than modern ones and has a longer life... I have already done noise insulation for it, now I decided to add lighting, it turned out very cool, here you go I decided to share a photo... I bought the backlight itself at a disassembly from an Electrolux machine for 500 rubles,...

Hello forum users! Due to an unexpected quarantine, a question was born (maybe not here...). The parents bought a Delongi DDW07T Onics dishwasher. Judging by the inscriptions, it was collected in Italy. And now they are afraid to open and install, they are talking about Coronavirus)))). Is it possible to somehow find out the model’s release date (month, year) by the serial number or barcode???? I...

Electrolux water supply machine, even she turned it off, a stream of water flows from there?! Why?

Hello. Choosing a 60cm dishwasher for a new apartment. So far I have chosen this electrolux ema917100l, but in the store the seller noticed that there was no upper sprinkler. Having looked at others, including those with a top tray for forks and spoons, I saw that some of them also do not have a top feed. That is, the water reaches the cutlery from the rocker between the lower and loaded upper...

Hello!
Last summer, a CANDY CDP 4609 dishwasher was purchased and placed on a summer veranda in the village. It worked all summer without problems (turned on no more than 10 times). For the winter she was sent to a heated house, which is located 5 meters from the veranda. After the weather warmed up (last weekend), the machine was returned to the veranda and connected. After turning on the power...

Can anyone tell me where the black rubber gaskets inside the dishwasher itself could have come from?
After the cycle was completed, I opened the door and found 4 pcs. such gaskets.