Bosch - Page 5

Do you still need a heating element?

The program does one rinse cycle and does not go further, it signals this and this may be error E6. What is this? Usually the PMM does three cycles (it’s clear that for any PMM model there is more than one cycle), rinsing two or more times with cold water so that the frozen food particles on the dishes soften, the third, or the last, final cycle is carried out with hot water.

Different PMMs may...

In general, after a month of using the new PPM, this seal fell off. This is the third or fourth time I’ve put it in place. I would like to understand the reason why this happens

Buy an old PMM, where there is an El mechanical timer, instead of control boards, and you will be happy.

I think this is protecting the drain pump impeller. You need to push it into place until it clicks.

Most likely there is water in the pan

Is it possible to change a loose nut on the aquastop of the PMM Ariston injection hose? How was it inserted, where can I get it? Can anyone tell me?

Aquastop worked. Emergency water pumping works (even when switched off). Look for a leak. You probably have water in the pan.

Like in photo-2?? Did I understand correctly? In general, I installed it as in photo 2. It seems to be in its place. I assembled the car and connected it. The machine started working (judging by the sounds it made). Water doesn’t flow anywhere. But! I opened it to check how it was inside, and it’s good that I opened it earlier. The water does not leave, it remains inside. Something responsible...

I would give a link where there are reviews .. but it won’t let me through (

radius was mistyped. not with the radius, but with the diameter.

In general, I didn’t drain it, I decided to check the cleaning filter, the movement of the pump impeller - everything seemed to be normal. Then I returned the pump cover to its place - it drained... BUT! I tried to set it to the soak-rinse mode - it seemed like the blades did not rotate and there was no such characteristic beating of water jets against the walls - maybe the problem is in the...

Can you tell me where this is located? water overflow nut ?
Inside (where the dishes are placed), on the left wall of the PMM. It looks like a barred gray window.

Hi all! I found a topic based on the PMM model and, in order not to create a similar one, I will continue the existing one.
So, at first I didn’t wash it until about rinsing. It was turned off by my wife on suspicion that the washing process took too long. Disabled. Looked around. Nothing but water in the pan. I did not completely remove the water with napkins. Did not help. I called a repairman...

Actually, this is the dishwasher fill valve.

I checked the heating element, everything is fine with it.

Yes, I checked everything that can be checked and found that on the control board elements near the varistor were damaged: two diodes - the markings of which I can read and two transistors - the markings of which are not readable - can someone tell me the markings of these transistors?