Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
dishes. machine NEFF S42M65N4EU (E-number S42M65N4EU/44)
Connected. Started to work.
works for 1 minute in any mode. then the timer is reset to 01 min. and shows E14
Problem:: E14
Fault in the drying system
Cause
Fault detected in the drying system or in the water supply system
Solution
Check the water supply system (whether the through-flow valve supplying the hose is not kinked). If repeated frequently, the device may malfunction.
dishes. machine NEFF S42M65N4EU (E-number S42M65N4EU/44) Connected. Started to work. works for 1 minute in any mode. then the timer is reset to 01 min. and shows E14
Problem:: E14
Fault in the drying system Cause Fault detected in the drying system or in the water supply system
Solution Check the water supply system (whether the through-flow valve supplying the hose is not kinked). If repeated frequently, the device may malfunction.
after turning on the dishwasher program, water fills in, then something clicks and it starts to squeak, drains water and at the same time fills in water. At the same time, there are no leaks in the dry pan. All filters are clean. At the end the faucet indicator lights up.
The dishwasher is filled with water, then it should spray. But this doesn’t happen. After turning off the device and repeating the operation, the water is pumped out. Then the water comes in and again nothing.
When you open the lid after taking in the water, the water stands at the bottom. Water flows without problems. Also, after draining, the machine is dry.
What could be broken or clogged?...
Like all Boshes, mine has a leak, but I couldn’t completely solve it; the homemade silicone gasket leaks during breaks for more than a week. This time I decided to take it apart and wipe it with a rag, but apparently the urine got to my head and I climbed from the right side, although it was possible from the facade, in short, I pulled the board off, after assembly it stopped heating, no errors....
Mobile version