Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
Experienced Gurus, please help, the PMM is flooding through a hole located on the left wall; a regulator with positions 1-2 is installed on it; it is in position 2, after I restored the operation of the input E/mag. valve stopped working water heating
Sent after 1 hour 16 minutes 10 seconds:
The heater is working, the machine is murmuring as if there is air in the system. When turned on, it began to leak, please tell me where leaks usually form.
Sent after 2 minutes 9 seconds:
Car Zanussi 5152, I think I indicated
Experienced Gurus, please help, the PMM is flooding through a hole located on the left wall; a regulator with positions 1-2 is installed on it; it is in position 2, after I restored the operation of the input E/mag. valve stopped working water heating
[size=85][color=green]Sent after 1 hour 16 minutes 10 seconds:[/color][/size] The heater is working, the machine is murmuring as if there is air in the system. When turned on, it began to leak, please tell me where leaks usually form.
[size=85][color=green]Sent after 2 minutes 9 seconds:[/color][/size] Car Zanussi 5152, I think I indicated
Hello, the Zanussi dishwasher refuses to work.
The bottom of the machine is flooded with water. When turned on, the lights come on, but the car does not come to life. They bailed out water, incl. from the filter; The machine started in the rinsing mode, but after a while it stopped - the puddle on the bottom appeared again (it seems to me that after removing the water in the washing mode, it did...
Good afternoon!
The question is: on the PMM the mode is 30 minutes. It washes until the end of the cycle and when there is already 1 minute left on the display (0 minutes), it waits and the time counter is set to 15 minutes and the PMM washes again. Those. It feels like the counter is being reset. PS: I’m not complaining about the quality of dishwashing
They give me the Zanussi PMM
She has a brush indicator lying around
According to the owner, it’s something with an optical sensor
Tell me, is this true?
Last post
The brush indicator lights up when the washing stage is in progress, blinking of this indicator indicates a system failure and may be accompanied by a sound signal, possible causes / aquastop has worked, water in the pan, problem with water intake, clogged filters in the PMM, clogged drain system water or sewerage, the drain hose is installed below 40cm/.
Hi all! zanussi ZDI101X The truth is somewhere nearby, but I just can’t find it. Everything started well. During the inspection, it became clear that the microphone in the door opening mechanism was broken; the machine considered the door open all the time. I block the microphone so that the door is always considered closed. I check, it starts to wash. Hooray! I turn off the program, assemble the...
Last post
Clean the pressure switch chamber from accumulations - a typical problem with the brand
Good afternoon!
I ask for help from experienced resuscitators PMM. The problem is this: there is a Zanussi ZDT92200FA pump, a pump, as I understand it, a disposable Blackmann one. The impeller fell apart into two halves, at the moment I tied it together with a thin plastic tie (which is used to tie electrical wires together) through three holes at the base, now the machine pumps like new. But I...
Last post
Does anyone have experience on how to securely fasten the two halves together?
soldering...yes, yes, with a soldering iron. nor use cyanoacrylate glue
Mobile version
