Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
Good afternoon!
The question is: on the PMM the mode is 30 minutes. It washes until the end of the cycle and when there is already 1 minute left on the display (0 minutes), it waits and the time counter is set to 15 minutes and the PMM washes again. Those. It feels like the counter is being reset. PS: I’m not complaining about the quality of dishwashing
Good afternoon! The question is: on the PMM the mode is 30 minutes. It washes until the end of the cycle and when there is already 1 minute left on the display (0 minutes), it waits and the time counter is set to 15 minutes and the PMM washes again. Those. It feels like the counter is being reset. PS: I’m not complaining about the quality of dishwashing
Hello. After turning on the machine, no errors are displayed on the indicator. But when choosing any washing program, the machine shows a significantly reduced time. For example, in the 70 degrees mode - 30 minutes instead of about two hours. Or in Auto 55-65 degrees mode for only 29 minutes. After starting the program, the machine hums and does not wash, water does not fill. What could be the...
Last post
Good afternoon The main problem is that water is not flowing into the dishwasher, we need to deal with it. Most likely the problem is in the aquastop, but there may be other options, look here in more detail:
Help please.
PMM thinks for a long time before starting to wash the dishes.
Input data. The PMM draws in water quickly and drains just as quickly.
I disassembled the PMM, on the motor that supplies water to the nozzles (where the heating element is still located), everything is fine - there is no dirt, nothing rubs or catches. I also blew out the pressure tube (it was free of contamination)....
Experienced Gurus, please help, the PMM is flooding through a hole located on the left wall; a regulator with positions 1-2 is installed on it; it is in position 2, after I restored the operation of the input E/mag. valve stopped working water heating
Sent after 1 hour 16 minutes 10 seconds:
The heater is working, the machine is murmuring as if there is air in the system. When turned on, it...
Hello, the Zanussi dishwasher refuses to work.
The bottom of the machine is flooded with water. When turned on, the lights come on, but the car does not come to life. They bailed out water, incl. from the filter; The machine started in the rinsing mode, but after a while it stopped - the puddle on the bottom appeared again (it seems to me that after removing the water in the washing mode, it did...
They give me the Zanussi PMM
She has a brush indicator lying around
According to the owner, it’s something with an optical sensor
Tell me, is this true?
Last post
The brush indicator lights up when the washing stage is in progress, blinking of this indicator indicates a system failure and may be accompanied by a sound signal, possible causes / aquastop has worked, water in the pan, problem with water intake, clogged filters in the PMM, clogged drain system water or sewerage, the drain hose is installed below 40cm/.