Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
Good day to all. There is a dishwasher built by Weissgauff (unfortunately I don’t know the model), which leaves water in the tray after the cycle. Previously, I drained the water completely. The filter is clean. The motor is working. The hose is clean. During the next wash cycle, it drains the water as expected at the very beginning. And this water drains completely. But then it remains. Can anyone tell me where to dig?
Good day to all. There is a dishwasher built by Weissgauff (unfortunately I don’t know the model), which leaves water in the tray after the cycle. Previously, I drained the water completely. The filter is clean. The motor is working. The hose is clean. During the next wash cycle, it drains the water as expected at the very beginning. And this water drains completely. But then it remains. Can anyone tell me where to dig?
Direct your thoughts, if possible, in which direction to look for the breakdown?
Dishwasher Weissgauff DW 4012 starts to work properly, but after about an hour of operation, in a heated state, it suddenly shows a squeaking error - icon rinse (according to the instructions - this icon also means an error code: lack of pressure in the water supply system or a faulty filling valve). But the...
Last post
The problem may be a faulty fill valve or drain pump. A malfunction of the pressure sensor in the water supply system may also be the cause. It is necessary to check these elements and, if necessary, replace them. It is also worth checking the condition of the dishwasher’s control electronics.
Yesterday I spent the whole day fiddling with my Bosch dishwasher.
The fact is that it suddenly stopped draining water. The beginning of the cycle is normal, water is drawn in, the dishes are rinsed, but when it comes to draining, there is silence and a burning faucet on the front panel.
It was clear that the drain pump was not working. This could be either because of the pump itself, or because...
Forum members, share your experience. How to drain the water from the dishwasher in the winter so that it does not defrost?
Last post
In the instructions for the Bosch PMM it is written how to prepare for wintering (the mechanism is the same as preparing for transportation), it is necessary to drain all the water from the tank, and not just drain the hose.
Hello! Stopped shooting tablet in the process of washing dishes. I took the door apart. I examined the contents. I rang the coil - 1333 Ohms. Everything is bad? The wires suitable for this coil go somewhere under the bottom of the machine. It’s worth going there and seeing something. If yes, then what? In general, I don’t understand anything about these matters. Or is it easier to order and...
Good evening
question about the Indesit dishwasher
I finished washing, I don’t unplug the machine, I make a new bookmark and select the washing mode. I turn on the start and: the machine drains the water, then, without ceasing to drain, the water set is turned on and the machine draws and drains water at the same time, after some time (30-60 seconds) it stops, and after a few seconds the water...