Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
The dishwasher draws water but does not wash. after a while the water drains. the master says circulation pump. pump price new 13k used 8k. Does anyone know if anyone can plug in any engine?
The dishwasher draws water but does not wash. after a while the water drains. the master says circulation pump. pump price new 13k used 8k. Does anyone know if anyone can plug in any engine?
I can’t figure out how to adjust the water hardness. According to the table from the manual, the water hardness setting data is given only in German degrees (’DH) and in mmol/l, and in accordance with these values, the softening level on the regulator is set (from H1 to H6). Our values in (G) are not there. I used a calculator of these values, it turned out that with our water hardness of 5F...
Last post
Watch fewer videos, and don’t worry about it, who needs recommendations from blogger babbles anyway? Everything is written in the passport!
Hello everyone!
Pmmm started to look like a wash. I ran the diagnostics and everything seemed to be normal. But! Measuring the temperature using a thermocouple on a multimeter, it turned out that the heater heats up to a temperature of 70 degrees and then turns off. The temperature drops to 24 and that’s it. Then at the end of the cycle it heats up again to 70 and turns off again. At the same...
Hello everyone!
Pmm it started to wash badly. I ran the diagnostics and everything seemed to be normal. But! Measuring the temperature using a thermocouple on a multimeter, it turned out that the heater heats up to a temperature of 70 degrees and then turns off. The temperature drops to 24 and that’s it. Then at the end of the cycle it heats up again to 70 and turns off again. At the same time,...
Last post
Good evening. I also encountered the same problem today. Has anyone solved it? I installed a new sensor, 10 kOhm. Some say you need to add resistance.
Mobile version