Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
The dishwasher is leaking. I replaced the pump seal, put it back, and stopped washing it. He pours water, opens the lid with detergent and stands silently. I changed the capacitor, nothing changed. But even with the old capacitor, the motor spins if you pull it out and plug it directly into the network. What could have happened?
The dishwasher is leaking. I replaced the pump seal, put it back, and stopped washing it. He pours water, opens the lid with detergent and stands silently. I changed the capacitor, nothing changed. But even with the old capacitor, the motor spins if you pull it out and plug it directly into the network. What could have happened?
Hello, I have PMM Candy. For two years it worked like clockwork, and then a terrible thing happened... (it started giving different errors every time... either there is not enough water, then it does not heat up to the required level... now it says that there is too much water coming in... Tell me if there is What’s the point in repairing? And what could it be?) Thank you.
Hi all!!! Guys, please tell me. The situation is as follows: the wash begins, water is drawn in, the impeller begins to rotate, i.e. washes. After some time, you just hear some kind of hum, you open the door, and there is simply no water in it. Who can say anything, maybe someone has encountered
dishwasher candy CD 702 T, is only on program P1, does not change when the buttons are pressed. after pressing start , water is supplied and drained. and the engine spins endlessly. please tell me what is the reason
Good afternoon, dears! PMM Candy CDI P96-07 takes in water and then drains. Do this three times. Then error E1 pops up (there are problems with water intake). In fact, it collects water and the pressure changes on the pressure switch. The tube through which pressure is supplied to the pressure switch is dry, clean and not pinched. If you blow into the pressure switch, the changeover contact is...
Last post
Look at the sensor (impeller + reed switch) on the water dispenser
Greetings. We have been using the Candy CSF 4575 E dishwasher for three years. Recently, this problem appeared. A salt coating began to remain on the dishes. We cleaned the finish cartridge. Today we noticed that even after pouring in the rinse aid, its level is not visible through the inspection window. In my opinion, the rinse aid simply does not flow further through the system. Tell me how to...
Mobile version