Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
On the PMM Kaiser there was a water leak on the hose, it was fixed. It worked for a week, then when the program is turned on, it takes in water {the bottom is opened and you can see how the tank is filling} a humming noise begins, but the pump does not turn on and hums. The recirculation pump is working properly. He pulled it out and connected it directly. I checked the capacitor is working properly. There are no more leaks. What else could it be? On the internet they also write electronics board. I would like to get to it last. But I couldn’t find any more options on the Internet about such a breakdown.
On the PMM Kaiser there was a water leak on the hose, it was fixed. It worked for a week, then when the program is turned on, it takes in water {the bottom is opened and you can see how the tank is filling} a humming noise begins, but the pump does not turn on and hums. The recirculation pump is working properly. He pulled it out and connected it directly. I checked the capacitor is working properly. There are no more leaks. What else could it be? On the internet they also write electronics board. I would like to get to it last. But I couldn’t find any more options on the Internet about such a breakdown.
Hello. The whirlpool dishwasher wsfe2b19eu ten is working, one of the thermistors barked, which has a red stripe. Tell me what to replace it with and what temperature to select
Greetings. IKEA began to leak, the master named the price at 7,000 rubles, Moscow. He said that he used sealant there, sealed the holes, etc. Real price or a scam? I also took the module for repairs, the relay on the diagram was fried, another 3600 for that. Tell me, did you overpay a lot?
One of the common reasons for dishwasher pump failure is wear of the graphite guides (bushings, plain bearings). Because of this little detail, you have to change the entire pump assembly, and that’s almost 10,000 rubles!
I offer a repair kit made from an alternative material with a friction coefficient equal to the original, and wear resistance - 2 times higher. Perfect alignment, tolerances...
Last post
radius was mistyped. not with the radius, but with the diameter.
There is no detergent flowing into the machine, but the dispenser is working. When you turn the dispenser manually, the detergent rises, and after stopping, the detergent goes back into the canister. What could be the problem?
Hello everyone, the motor of the water distributor valve has burned out, I’m looking for the motor, I can’t find it anywhere, has anyone replaced it or found one for sale?
It is found in many devices
Sent after 3 minutes 48 seconds:
Does anyone know if it is possible to replace the valve assembly itself with another one? There is a seat model the same as at my valve
Mobile version
