Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
The main water pump does not turn on. Pumping is working. The leakage contact is not stuck. The hand programmer clicks. and that’s it. What should I do??
The main water pump does not turn on. Pumping is working. The leakage contact is not stuck. The hand programmer clicks. and that’s it. What should I do??
Does anyone have a service manual or at least a piece with a wiring diagram? nThe machine was received with the brains disconnected and the cables untwisted. Intuitively, and with measurements, everything seemed to be connected, but to check, I think we need to be on the safe side.
Hello friends.
Please tell me about this dishwasher.
After starting the washing program, the pump starts pumping water and does not stop. Water begins to flow out from under the door, everything flows into the pan. In principle, there is no emergency flood sensor in the pan. The float with two limit switches appears to be normal, the limit switches work. True, one is connected as normally...
Last post
They say this happens because the sensor that is responsible for the water level is filled with fat. Fat sticks to it and it remains in the position that there is no water yet. and pours endless amounts of water. To get rid of the problem, we need to disassemble or wash the grease trap so that the sensor can move freely and nothing interferes with it
I was told by a dishwasher installation company that it is necessary to pull a wire from the panel and install a separate machine for the machine.
Are they scamming me out of money or is it really necessary? Does a dishwasher really consume so much power that you can’t do without a separate wire?
Last post
It is terribly stupid to change an automatic machine if it seems that it is “weak”! The machine must protect the wiring, not the equipment or itself from being turned off! You cannot increase the machine without increasing the cross-section of the wire! Otherwise, a fire is quite likely.
Comrades, good afternoon!
Does anyone have a diagram or photo of connecting the wires to the control module of the specified device. Bosch responds to inquiries: contact an official service center. And I’ve already said enough, that’s enough.
Mobile version
Автор темыaleksandr
Evgenia.smolenskaya
