Dear dishwasher owners! We are trying to collect here as much useful information as possible about dishwashers, so if you have something to say, say it. :-) (even without registration)
During washing there was a burning smell. It turned out that the connector from the sink to the board had melted (the “mother” chip on the board was also a little). What could be the reason? The module was changed 3 years ago. The car wash is 10 years old. One specialist advises the heating element to check the capacitor as well. What other reason could there be? What else needs to be checked?
During washing there was a burning smell. It turned out that the connector from the sink to the board had melted (the “mother” chip on the board was also a little). What could be the reason? The module was changed 3 years ago. The car wash is 10 years old. One specialist advises the heating element to check the capacitor as well. What other reason could there be? What else needs to be checked?
I started the dishwasher (ESL45010 911635220), after a while the RCD in the apartment panel tripped.
I turned the RCD back on, the dishwasher continued to work, but at the end of the wash the dishes were cold .
After this incident, the machine does not show any errors, but washes it with cold water as it goes.
I understand that the problem could be anything: heating element,...
image.jpg Hello, the plug on the shade has melted. I have a question: is it possible to solder the wires directly to the terminals of the heater. As far as I understand, the plug is needed only for quick installation and dismantling of the heater
Mobile version